Search results for " layers"
showing 10 items of 91 documents
A Local Study of the Transport Mechanisms in MoS2 Layers for Magnetic Tunnel Junctions
2018
MoS2-based vertical spintronic devices have attracted an increasing interest thanks to theoretical predictions of large magnetoresistance signals. However, experimental performances are still far from expectations. Here, we carry out the local electrical characterization of thin MoS2 flakes in a Co/Al2O3/MoS2 structure through conductive tip AFM measurements. We show that thin MoS2 presents a metallic behavior with a strong lateral transport contribution that hinders the direct tunnelling through thin layers. Indeed, no resistance dependence is observed with the flake thickness. These findings reveal a spin depolarization source in the MoS2-based spin valves, thus pointing to possible solut…
The impact of temperature on electrical properties of polymer-based nanocomposites
2020
This work was supported by National Research Foundation of Ukraine, project 2020.02/0217. IK would also like to thank VIAA, State Education Development Agency for Latvian state fellowship. HK would like to thank Ministry of Education and Science of Ukraine, project for young researchers No. 0119U100435. In addition, SP and AAP are thankful for financial support from Latvian Council of Science via grant lzp-2018/2-0083. HK and AAP are grateful for the support from the COST Action CA17126.
Thermal and structural modeling of the Scillato wedge-top basin source-to-sink system. Insights into the Sicilian fold-and-thrust belt evolution (Ita…
2019
AbstractTemperature-dependent clay mineral assemblages, vitrinite reflectance, and one-dimensional (1-D) thermal and three-dimensional (3-D) geological modeling of a Neogene wedge-top basin in the Sicilian fold-and-thrust belt and its pre-orogenic substratum allowed us to: (1) define the burial history of the sedimentary succession filling the wedge-top basin and its substratum, (2) reconstruct the wedge-top basin geometry, depocenter migration, and sediment provenance through time in the framework of a source-to-sink system, and (3) shed new light into the kinematic evolution of the Apennine-Maghrebian fold-and-thrust belt.The pre-orogenic substratum of the Scillato basin shows an increase…
Controlled 3D Interfacing of Three Components Thin Films for Photovoltaics
2013
One of the main problems related to the low performance of the organic photovoltaic (OPV) devices, concerns the low mobility of the materials forming the heterojunction. For this reason, there is competition between the sweep-out and recombination of the photogenerated carriers within the thin film bulk heterojunction (BHJ). To overcome this problem, it is usual to operate by reducing the thickness of the active layer, so that the recombination of charge carriers is inhibited. This choice, however, also translates into a lower absorption of light by the active film itself. Plasmonic structures allow to reduce the "physical" thickness of heterojunction, maintaining constant the "optical" thi…
Anatase nanoparticles boundaries resulting from titanium tetrachloride hydrolysis
2017
An important factor that governs solar energy transformation into electrical or chemical energy, when using nanoparticles-based devices, is the spatial location of traps limiting electron transport. Evidences have been presented indicating that the electron diffusion is strongly influenced by nanoparticle boundaries, whose characteristics depend on the particles preparation. In the present work we have studied the role of hydrated excess proton structures in the formation of anatase nanoparticles boundaries in samples prepared by TiCl4 hydrolysis at low temperature and strong acidic conditions. The samples, constituted by anatase nanocrystals but, mainly, by amorphous titania, are studied b…
Study of the Chemical Conversion of Aluminum Alloys by Coupling CFDE and EQCM
2004
The ability of the channel flow double electrode (CFDE) technique and electrochemical quartz crystal microbalance (EQCM) for studying in situ chromate phosphate conversion coating on 5182 aluminum alloys was explored. It was first demonstrated that aqueous Cr(VI) can be analyzed quantitatively with the CFDE technique by reduction into Cr(III) on a graphite electrode. Samples used for EQCM were quartz plated by physical vapor deposition using a 5182 alloy target, allowing thin layers of aluminum alloys with a similar chemical composition to be obtained. EQCM was adapted in order to account for the hydrodynamic conditions in an industrial process, by placing the quartz in a flow cell. In orde…
Depth selective Mössbauer spectroscopy: Analysis and simulation of 6.4 keV and 14.4 keV spectra obtained from rocks at Gusev Crater, Mars, and layere…
2008
[1] The miniaturized Mossbauer spectrometer (MIMOS) II Mossbauer spectrometers on the Mars Exploration Rovers (MER) simultaneously obtained 6.4 keV and 14.4 keV Mossbauer spectra from rock and soil targets. Because photons with lower energy have a shallower penetration depth, 6.4 keV spectra contain more mineralogical information about the near-surface region of a sample than do 14.4 keV spectra. The influence of surface layers of varying composition and thickness on Mossbauer spectra was investigated by Monte Carlo simulation and by measurement using a copy of the MER MIMOS II instrument and samples with one or two layers of known thicknesses. Thin sections of minerals or metallic Fe foil …
Evaluation of the bending behaviour of laminated glass beams via electronic speckle pattern interferometry
2017
The paper is devoted to the experimental analysis of the kinematical and mechanical behaviour of laminated glass beam structures. In particular, the utilized laminated glass specimens are composed of two glass layers bonded by a polymer layer constituted by Ethylene-vinyl acetate whose thickness has been nominally considered as constant for all the specimens. The experimental behaviour of the analyzed specimens is deduced by applying Electronic Speckle- Pattern Interferometry technique; actually, among optical methods this technique (handled by phase-stepping technique) is very effective to obtain a full-field displacement map and to numerically achieve the longitudinal strain. In particula…
SMOS REFLEX 2003: L-band emissivity characterization of vineyards
2005
The goal of the Soil Moisture and Ocean Salinity mission over land is to infer surface soil moisture from multiangular L-band radiometric measurements. As the canopy affects the microwave emission of land, it is necessary to characterize different vegetation layers. This paper presents the Reference Pixel L-Band Experiment (REFLEX), carried out in June-July 2003 at the Vale/spl grave/ncia Anchor Station, Spain, to study the effects of grapevines on the soil emission and on the soil moisture retrieval. A wide range of soil moisture (SM), from saturated to completely dry soil, was measured with the Universitat Polite/spl grave/cnica de Catalunya's L-band Automatic Radiometer (LAURA). Concurre…
Structural and Chemical Characterization of Cerium Oxide Thin Layers Grown on Silicon Substrate
2015
In this study, we report transmission electron microscopy and electron energy loss spectroscopy study of cerium oxide thin layers deposited on silicon substrate. Transmission electron microscopy experiments have revealed the flat morphology of the deposited layers. In addition, studies of high resolution images have indicated the presence of mainly ceria crystallized nanoparticles. Energy electron loss spectroscopy measurements were also performed in scanning mode to study the evolution of the cerium valence. In addition to Ce4+ inside the layer, the presence of amorphous cerium silicate with valence +3 is pointed out at the vicinity of the substrate.